[. . . ] Dragon Timer operation
First set the digital clock to the correct time · Press hour button until the display shows the correct hours · Press min button until the display shows the correct minutes To adjust time once set, hold the hour or min button down for at least 5 seconds until the display starts flashing, then proceed as above. [. . . ] Finally set the confort temperature using thermostat buttons 1 and 2 The set temperature is shown on the right hand side of the display To cancel a programme, press timer button A or B once and then press the hour button until the display shows " ".
:
AUTO
:
Timer Override To operate the appliance without using the timer, press ON/MODE button The yellow TIMER ON lamp will go off To go back to timed operation press timer button A or B.
Dragon To switch the heater on
1) Press ON/MODE button as shown below: Press once for Maximum Power:
MAN
:
°C
Correct time
Set temperature
De'Longhi quick guide
Press twice for Medium Power:
MAN
0
AUTO
MAN
°C
:
:
°C
Press three times for Minimum Power:
MAN
:
°C
ON MODE button
Press four times for Off:
AUTO
Thermostat button 1
Thermostat button 2
:
O
2) Set the comfort temperature required by using thermostat buttons 1 and 2. The set temperature is shown on the right hand side of the display 3) The Electronic Climate Control selects the ideal power setting to maintain your chosen temperature. Please note:The power setting you have selected will be the maximum setting the heater works at.
If your heater is not working: · Check the timer light is not on. · The room temperature may be higher than the selected temperature; therefore the heater has turned itself off. [. . . ] For full details please read the instruction booklet
5710008700/05. 04 [. . . ]